98 products were found matching your search for Effluent in 1 shops:

The SaniPlus is a system that is used to install a complete bathroom up to 15 ft. below the sewer line, or even up to 150 ft. away from a soil stack. It can handle the effluent from a toilet, sink, bathtub and shower. The inside of the SaniPlus comprises of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel macerator blades and the pump. When the flush is activated, the water flowing into the SaniPlus activates a micro switch in the pressure chamber, which in turn starts the motor. The motor is sealed for life in an oil filled enclosure. A common spindle/shaft drives the impeller and the macerator blades. The moving parts therefore are kept to an absolute minimum. Water and organic waste matter enter the chamber and are reduced to slurry as the macerator blades rotate at 3600 RPM. The centrifugal force causes the reduced solids to be ejected through a grill into the container where it is picked up by the impeller pump mounted beneath the motor. The unit pumps the effluent upward to 15 ft. and/or 150 ft. horizontally (with gravity fall). Once the water level in the container goes down, the micro switch deactivates the unit until the flush is activated again. A normal operating cycle for SaniPlus takes about 10 to 15 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal. In addition to the toilet waste, the SaniPlus will also discharge gray water from a variety of other.

The Saniaccess3 is a system that is used to install a complete bathroom up to 15 ft. below the sewer line, or even up to 150 ft. away from a soil stack. It can handle the effluent from a toilet, sink, bathtub and shower. The Saniaccess3 is simplicity itself to install; there are just four connections.

Liberty's LE50-series cast iron sewage pump is a commercial-grade workhorse for residential and light commercial applications. Its efficient 1/2 hp motor with permanently lubricated bearings, stainless steel fasteners and quick-disconnect power cord design make this a favorite choice among professionals. Other features include 2 in. solids-handling ability and a shut-off head of 25 ft.

Installing an extra toilet and vanity in a shed, man cave or outdoor living space has never been easier thanks to the new SaniAccess 2 macerator pump. The SaniAccess 2 will allow anyone to install a toilet and vanity anywhere they want. With two removable panels on top of the unit, servicing and maintenance has never been easier. Periodic maintenance can be accomplished quicker and easier than ever without having to disconnect the unit from either the toilet or the rest of the plumbing system. The SaniAccess 2 will macerate and pump out the waste up to 5 meters high or up to 100 meters away from the sewer line. All waste is pumped through a 20 mm pipe to reach the nearest sewer line, avoiding any major work.

The Superior Pump 1/3 HP submersible effluent pump will move up to 60 Gal. of water per minute. This pump is made of rugged cast iron and includes an adjustable tethered float switch with piggy back plug to automatically turn the pump on/off. The 92305 offers a powerful, yet energy efficient (7.6 Amp) thermally protected motor for longer life and durability. The pump features a thermoplastic, non-clogging vortex impeller, 1-1/2 in. FIP discharge and 10 ft., replaceable, water proof power cord. This sump pump has side inlets for increased water flow and will handle 5/8 in. solids. UL/CUL listed and CSA certified and backed by a 1 year warranty.

The Aero-Stream effluent filter is a great feature to have in any septic or aerobic treatment tank. These filters are designed to trap large and fine particles. The large surface area prolongs the maintenance schedule.

Little Giant 6EC Series pumps feature 1/3 HP Permanent Split Capacitor (PSC) motors providing lower current draw, energy efficiency, improved performance and cooler-running for durability. Built on the industry's best 6E platform, the 1/3 hp 6EC series consumes only 5.0 amps while producing 53 gpm at 5 ft. of head and reaching a maximum shut off of 28 feet. This equipment should be installed and serviced by technically qualified personnel.

The 9SC Series submersible effluent pump from LITTLE GIANT is specifically engineered to handle the tough demanding tasks for wastewater and effluent waste transfer with high efficiency and long term dependability. Ideal for use in residential, commercial, industrial, and agricultural applications with light to medium transfer demands such as dewatering, effluent waste, wastewater, and handling where such materials must be moved upward from a collection area to sewer lines, septic lines, or drainage areas. The 2-pole motor provides increased speed and yields higher performance at higher heads.

A reliable laundry tray pump with simple switch adjustment. Makes laundering completely automatic. Easily installed with our patented "Quick Mount" fitting. There are no external moving parts and no water circulates in the switch.

The Aero-Stream effluent filter is a great feature to have in any septic or aerobic treatment tank. These filters are designed to trap large and fine particles. The large surface area prolongs the maintenance schedule.

LEO sewage/effluent pumps operate automatically with a piggy-back float switch. They are designed for long-lasting, quiet operation, used to pump out liquids and solids up to 2 in. Dia. The most common application is for specific system or sewage pit.

The Liberty Pump LE41A is an automatic submersible sewage pump with 4/10 HP and 115-Volt motor. The 10 ft. quick-disconnect power cord allows replacement of cord in seconds without breaking seals to motor. The Liberty sewage pump is equipped with an adjustable wide-angle switch that has a piggyback series plug for manual bypass operation. In the event of switch failure, the submersible sewage pump cord can be separated and plugged into the electrical outlet, directly bypassing the switch.

This sewage pump is the perfect choice for residential sewage systems. Whether you need to drain a flooded basement or remove wastewater from a pond, it can handle any draining job with ease. Its rugged construction and large discharge make it durable and effective for draining jobs. It is specifically designed for removing sewage, wastewater, and rainwater in basements, sump pits, bathrooms, yards, or toilets, helping you do the dirty, smelly tasks and keeping your home dry and clean.

Epoxy-coated cast iron cover, housing and volute. Carbon/ceramic mechanical shaft seal; cold-rolled steel shaft and upper and lower ball bearings. CONTINUOUS DUTY MOTOR: Features an energy-efficient 115-Volt, 8 Amp, standard 10 ft. power cord. AUTOMATIC OPERATION: Snap-action float switch turns pumpon when water reaches 8 to 11 in. and shuts pumps off when water drops to between 2 and 5 in. SOLIDS HANDLING: handles up to 3/8 in. semi solids suitablefor light effluent waste.

This sewage pump, with a powerful copper wire motor, drains water at up to 5220 GPH and lifts water up to 24 ft., making sewage removal easier than ever before. The oil-filled split capacitor effectively cools the unit, ensuring longer work times. Rustproof, corrosion-resistant and ultra-sturdy cast iron housing means this pump will last and withstand harsh elements. Designed for residential sewage and septic systems, it's ideal for removing sewage, wastewater and rainwater in basements, bathrooms, yards or septic tanks, helping you do the dirty, smelly jobs and keep your place dry and clean.

The Aero-Stream effluent filter is a great feature to have in any septic or aerobic treatment tank. These filters are designed to trap large and fine particles. The large surface area prolongs the maintenance schedule.

This sewage pump is the perfect choice for residential sewage systems. Whether you need to drain a flooded basement or remove wastewater from a pond, it can handle any draining job with ease. Its rugged construction and large discharge make it durable and effective for draining jobs. It is specifically designed for removing sewage, wastewater, and rainwater in basements, sump pits, bathrooms, yards, or toilets, helping you do the dirty, smelly tasks and keeping your home dry and clean.

The K2 Pumps 3/4 HP CONTRACTOR SERIES Sump and Effluent Pump is designed for residential and light commercial applications with up to 3/4 in. spherical solids handling. Engineered with heavy-duty materials, energy-efficient PSC motor, and maximum performance, the K2 CONTRACTOR SERIES pumps are built to last. Typical applications include commercial sump pump applications, Onsite or Septic Tank applications, Enhanced Flow STEP systems, Sump/Dewatering, and Low Pressure Pipe (LPP).

Epoxy-coated cast iron cover, housing and volute. Carbon/ceramic mechanical shaft seal; cold-rolled steel shaft and upper and lower ball bearings. CONTINUOUS DUTY MOTOR: Features an energy-efficient 115-Volt, 8 Amp, standard 10 ft. power cord. AUTOMATIC OPERATION: Snap-action float switch turns pumpon when water reaches 8 in. to 11 in. and shuts pumps off when water drops to between 2 and 5 in. SOLIDS HANDLING: handles up to 3/8 in. semi solids suitablefor light effluent waste.

[BUILT TO LAST]: This 1/2 HP effluent pump can drain water at up to 4200 GPH and lift water up to 79 feet, making sewage removal easier than ever. Features a cast iron cover, housing, and volute, along with a carbon mechanical shaft seal and stainless steel shaft with open ball bearings.[CONTINUOUS DUTY MOTOR]: Equipped with a 115-volt, 14 Amp,insulation energy-efficient motor for improved performance, and includes a standard 20-foot power cord.[SOLIDS HANDLING]: Capable of handling up to 3/4-inch spherical solids, making it suitable for light effluent waste.